Essentials of electric bicycles
2022-12-17
The use of electric bicycles is as follows: Start Like driving cars, riding one -run Electric Mountain Bike should start in a medium and low -speed gear to make the bicycle get enough motivation, while ensuring that the motor is not overloaded. After starting, add to the appropriate gear according to the speed, load and road conditions. When the speed is not significantly improved after the speed of the plus gear, it means that the motor may be overloaded, and the file should be reduced immediately, or the feet are helpful. Brake The front wheels use high -sensitive disc brakes, and the rear wheels use a better brakes or double -drive disc brakes. The ebike brake distance is short. Moreover, a high -sensitive brake power off device is used to squeeze the power to disconnect the power instantly. When the brakes, the handle must be returned. When starting again, let go of the gate first, and then slowly turn the right hand to turn the handle. Avoid loose gates when the handle was not returned, and the bicycle suddenly came out, causing danger. High -speed riding In the case of light loads with good road conditions, you can use the highest speed or highest speed gear to step on the help. Note that if the speed cannot exceed 40 kilometers/hour, do not use the highest speed gear, but should be ride appropriately. Overload When the carrier is loaded, due to the increase in motor load, mid -speed or low -speed ride should be used. Moreover, choose the right gear according to the load. One point must be emphasized that the increase in loads and vehicle resistance increased accordingly, and it is impossible to have the same ride speed. Electric Bike will be counterproductive to get high -speed gears in order to obtain high speed. Because in this case, the use of high -speed gears not only cannot increase the speed, but will cause the motor to overload, increase power consumption, reduce efficiency, and even burn the motor. Urban ride Due to the dense population and complex road conditions in the urban area, frequent brakes, deceleration, and startup are required. The medium speed gear should be adopted by the front change, and 5 or 6 gear is used in the rear transmission. Long -distance riding Any battery has a certain itinerary limit. The 36 volt and 20 -in -the -time battery theoretically, the pure electric itinerary is 50 to 60 kilometers. If you plan to ride a one -hundred -kilometer distance, you need to increase the backup battery or step on. The alternation of electric and feet is the most effective way to increase the itinerary without battery. Reducing resistance is the basis for increasing the itinerary. Insufficient tire pressure, car shafts, brakes and other car conditions are not good, it will increase power consumption and reduce the itinerary. It is very important to maintain and adjust vehicles. Ride at night Due to poor sight at night, you should use low -speed stalls slowly, and you must turn on the front and taillights, so that other pedestrians and vehicles can find you far away. Drive upstairs In advance, the front and rear speeds are adjusted to the minimum speed gear, while pushing up the stairs and turning to the turn, easy to go upstairs.
